Digital ECU Tuner 3 bez map senzoru

Digital ECU Tuner 3 bez map senzoru

4.351,00  vč. DPH (3.595,87  bez DPH)

Dostupné na objednávku

Popis

Digital ECU Tuner 3 je nejpopulárnější zařízení typu „piggy back“ na trhu. Díky svým vlastnostem a atraktivní ceně se skupina spokojených zákazníků stále rozrůstá.

Technické detaily:

  • four 16×16 side tables (fuel map,two PWM tables, ignition table),
  • 8 Correctiontables 16×1,
  • 2 independent switchable map sets ,
  • possibility modification of one analogue signal,
  • 4 analogueinputs,
  • inbuilt Data Flash – possibility of logging without connected PC,
  • battery voltage monitoring ,
  • support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz,
  • support VR and Hall effect crank sensors together with ignition modules pulse. Device supportbothsingle ended and differential signals,
  • supports a lot of crank trigger patterns :60-2, 36-2, 36-1, Multitooth, Ignition Modules and more,
  • support of waste gate valve,
  • output for 4 saturated injectors („full group“),
  • ON/OFF parametricoutput,
  • automatic conversion of MAP to MAF with the use of the learning algorithm,
  • launch control,
  • road dyno,
  • possibility individual calibration of each analogue sensors – device displayed values with correct units,
  • free firmware update – new crank trigger patterns and new functionality,
  • fuel Implant mode –possibility of drive injectors in standalone mode (batch fire),
  • USB communication no additional interface needed,
  • 24 months warranty.

PC Requirements:

To properly work with the DET3 device following minimum is required.

  • Windows 2000, XP, Vista, Windows 7, Windows 8
  • Screen resolution of at least 1024×768 16bit
  • CPU with a clock of at least 600MHz,
  • USB port.

Co najdete v balení

  • Digital Ecu Tuner 3 zařízení,
  • USB AA kabel,
  • konektor,
  • set kontaktů do konektoru,
  • CD se softwarem,  potřebné ovladače a uživatelský manual,
  • sada resistorů a diody užitečných při instalaci.