Popis
Digital ECU Tuner 3 je nejpopulárnější zařízení typu “piggy back” na trhu. Díky svým vlastnostem a atraktivní ceně se skupina spokojených zákazníků stále rozrůstá.
Digituner zároveň obsahuje map senzor.
Technické detaily:
•four 16×16 side tables (fuel map,two PWM tables, ignition table),
•8 Correctiontables 16×1,
•2 independent switchable map sets ,
•possibility modification of one analogue signal,
•4 analogueinputs,
•inbuilt Data Flash – possibility of logging without connected PC,
•battery voltage monitoring ,
•support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz,
•support VR and Hall effect crank sensors together with ignition modules pulse. Device supportbothsingle ended and differential signals,
•supports a lot of crank trigger patterns :60-2, 36-2, 36-1, Multitooth, Ignition Modules and more,
•support of waste gate valve,
•output for 4 saturated injectors (“full group”),
•ON/OFF parametricoutput,
•automatic conversion of MAP to MAF with the use of the learning algorithm,
•launch control,
•road dyno,
•possibility individual calibration of each analogue sensors – device displayed values with correct units,
•free firmware update – new crank trigger patterns and new functionality,
•fuel Implant mode –possibility of drive injectors in standalone mode (batch fire),
•USB communication no additional interface needed,
•24 months warranty.
PC Requirements:
To properly work with the DET3 device following minimum is required.
•Windows 2000, XP, Vista, Windows 7, Windows 8
•Screen resolution of at least 1024×768 16bit
•CPU with a clock of at least 600MHz,
•USB port.
Co najdete v balení
•Digital Ecu Tuner 3 zařízení,
•USB AA kabel,
•konektor,
•set kontaktů do konektoru,
•CD se softwarem, potřebné ovladače a uživatelský manual,
•sada resistorů a diody užitečných při instalaci.
